Figure 6-26 Adding video information
Figure 6-27 Password for accessing the IP camera ONVIF interface
Step 4 After entering the video information, click Conrm.
Step 5 In the Video Information list, click the link under the Link column and go to the
camera WebUI as prompted.
Step 6 For details about how to commission the camera and set parameters, see the
documents delivered with the device or the documents obtained by referring to
the "Preparing Documentation" section.
1. Preview the site situation in real time and check the camera coverage through
videos. Adjust the lens if necessary.
2. (Optional)
Congure an SD card if the VCN is not congured.
3. Choose Settings > Video/Audio/Image > Video Settings, and set camera
stream type, primary stream, and secondary stream 1 parameters.
ECC800 Data Center Controller
User Manual (for ECC800-Pro) 6 Feature Description
Issue 02 (2020-09-07) Copyright © Huawei Technologies Co., Ltd. 159
To Next Page
Loading...
