Huawei ECC800-Pro - Page 176

Settings Action
Enable TLS 1.1 or TLS 1.2.
NOTE
You must enable TLS 1.1 or TLS 1.2
when the Hypertext Transfer Protocol
Secure (HTTPS) protocol is used to
access the IPC. Otherwise the camera
web interface cannot be accessed.
1. Choose Tools > Internet
Options.
The Internet Options dialog box
is displayed.
2. Click the Advanced tab.
3. Select Use TLS 1.1 or Use TLS 1.2.
4. Click OK.
Set Use Pop-up Blocker to Disable. 1. Choose Tools > Internet
Options.
The Internet Options dialog box
is displayed.
2. Click the Security tab.
3. Click Internet.
4. Click Custom level.
The Security Settings-Internet
Zone dialog box is displayed.
5. Set Use Pop-up Blocker to
Disable.
6. Click OK.
Step 2 For details about how to commission IP cameras and set parameters for them, see
the documentation delivered with the equipment or obtain the documentation by
referring to the "Preparing Documentation" section.
1. Preview the site situation in real time and check the camera coverage through
videos. Adjust the lens if necessary.
2. Choose Settings > Network
Conguration > Network Parameters, and set
IPv4 address, IPv4 Subnet mask, and IPv4 Gateway address for the camera
according to the site plan.
3. Choose Settings > Video/Audio/Image > Video Settings, and set camera
stream type, primary stream, and secondary stream 1 parameters.
NO TICE
Set the encoding protocol to H.265.
ECC800 Data Center Controller
User Manual (for ECC800-Pro) 6 Feature Description
Issue 02 (2020-09-07) Copyright © Huawei Technologies Co., Ltd. 165