G1E Programming Manual
95
05. DTMF CID Leading Digits :
This parameter enables/disables the display of Leading digits on DTMF Call ID
example: D0289661356C
Leading code =D
Trailing code = C
0= no code 1=A 2=B 3=C 4=D 5=* 6=# 7=only display telephone number
06. DTMF CID Trailing Digits:
This parameter enables/disables the display of Trailing digits on DTMF Call ID
example: D0289661356C
Leading code =D
Trailing code = C
0= no code 1=A 2=B 3=C 4=D 5=* 6=# 7=only display telephone number
07. CID Call Block or Transfer to Voice Mail:
This parameter allows to system to reject or send to a virtual Voicemail, incoming calls based on the CID
received from the call. When a call is rejected the LED for the line will flash but there will be no audible
ring. CID numbers to be screened must be specified in Mode 09 system speed dial. Mode 05-14-06
must also be enabled to make this feature work.
0 = Disable 1 = LED Flash only 2 = Transfer to Virtual Mailbox. (Default Mail box: 141)
Associated program modes 09, 05-05-05, 05-14-06, 43-51-05, 43-52-05, 43-53-05
08. Minimum Mail Box Record Time:
This parameter sets the minimum length message that the VMU Mailboxes will record. If the Busy Tone
detect takes a period of time to clear down the call then the mailbox owner will hear busy tone and may
think calls are being cut off. Setting this parameter will not allow any call to be recorded until the time is
reached.
0 = Disable 1 = 1 second 2 = 2 seconds 3 = 3 seconds
4 = 4 seconds ………………………….. 9 = 9 seconds
TIMING TABLE
Grade 0 1 2 3 4 5 6 7 8 9 unit
C 0 4 6 8 15 30 60 120 254 sec.
To Next Page
Loading...