HYBREX G1E - Call Forward Busy Transfer Group:

G1E Programming Manual
171
04. Call Forward Busy Transfer Group:
This parameter sets the Permanent Call Forward Busy destination Hunt Group for the Station. If the Station user
sets a Call Forward manually then it will override this setting but after cancelling the manual Call forward then
this setting will be enabled again.
See also Mode 46-stn-07 – Call Forward Busy permanent setting.
0 = Disable 1 = Group 1 2 = Group 2 - 9 = Group 9
05. External Notification – Voicemail:
The system will check stations every 30 seconds looking for new mail messages. If yes, the system will select an
idle CO line to dial out xx times according to the setting in mode 78-st-05. After the number is dialled, system will
announce “you have x new message, please enter your password” four times . If the entered password is correct
and all new messages are heard, system will stop dialling. System will only use one CO line to activate the
notification function at a time.
Mode 78-st-05 = 0 Disable the notification.
Mode 78-st-05 = 1 Dial the specified number three times to notify the user.
Mode 78-st-05 = 2 Dial the specified number six times to notify the user.
:
Mode 78-st-05 = 9 Dial the specified number until the user answers and enters the correct password
06. Calling Line Identification Presentation:
This parameter selects what CLIP information will be presented to the Exchange when a Station makes an
outgoing call. Not all exchanges will accept and pass on this information and if A CLIP is entered in mode 71 that
is not a valid number in the assigned range of the customer the exchange will ignore this information also.
Special CLIP information can be entered in mode 71 which contains 6 different tables.
MODE-78-ST-06 = 0 caller party number follow MODE-72-st to dial
MODE-78-ST-06 = 9 CLIR
MODE-78-ST-06 = 1-8 refer to MODE-71 (01-08)
07. Ring Line Preference:
This parameter sets whether an extension will answer a trunk ringing at that extension by lifting the handset or
will need to press the DSS key of the ringing trunk or use pickup if the trunk is not displayed.
0 = Auto Answer 1 = Manual Answer
08. Reserved: