HYBREX G1E - Program 18-Nn-Tk: Assign Toll Plans to Trunk Lines

G1E Programming Manual
125
Program 18-nn-TK : Assign Toll Plans To Trunk Lines
18-nn-tk Toll
0000000000
nn = Toll plan number (00-09), tk = (01-10)
Toll class for each trunk (class 0-9)
General:
This Mode assigns Toll Plans to trunk lines. The Toll plans are to be written in Modes 51 to 59 and 61 to 66.
Description:
10 toll plans can be used.
Each Toll Plan assigns each trunk line a Toll Class. It is possible to allow a toll class to have different restriction
level on a line by line basis.
Example 1: Mode 18-00 is set to 0000dddddd. Any station in the system which is set to toll class 0 will be
unrestricted on lines 1 to 4 but will be unable to dial out on lines 5 to 10.
Example 2: Mode 18-01 is set to 111100dddd. Any station in the system which is set to toll class 1 will be
restricted by toll class 1 on lines 1 to 4, will be unrestricted on lines 5 and 6 but will be unable to dial out on lines
7 and 10.
To assign toll plans to stations, see Program 41-st-05, 41-st-06.
Toll Classes:
Class Function Prog. Mode
0
Unrestricted Default
1
Use Mode 51 for the Unrestricted numbers. Use Mode 61 for the Restricted numbers
Mode 51,61
2
Use Mode 52 for the Unrestricted numbers. Use Mode 62 for the Restricted numbers
Mode 52,62
3
Use Mode 53 for the Unrestricted numbers. Use Mode 63 for the Restricted numbers
Mode 53,63
4
Use Mode 54 for the Unrestricted numbers. Use Mode 64 for the Restricted numbers
Mode 54,64
5
Use Mode 55 for the Unrestricted numbers. Use Mode 65 for the Restricted numbers
Mode 55,65
6
Use Mode 56 for the Unrestricted numbers. Use Mode 66 for the Restricted numbers
Mode 56,66
7
Use Mode 57 for the Unrestricted numbers.
Mode 57
8
Use Mode 58 for the Unrestricted numbers.
Mode 58
9
Use Mode 59 for the Unrestricted numbers.
Mode 59
*
Use Mode 51-56 for unrestricted numbers. Use Mode 61-66 for all restricted numbers
D Cannot access the trunk line.