EasyManua.ls Logo

HYBREX G1E - Program 42-Stn-Ip: Register Memory Blocks for Individual Speed Dial

Default Icon
219 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
142 Issue 3.3.2 / April, 2011
Program 42-stn-IP : Register Memory Blocks for Individual Speed Dial
42-stn-IP SPD-T
b1 b2
st = Station No. (2-4 digits) IP = 01-02
blocks (2 max.) for a Station
b1: Block 1 of Individual Speed Dial Codes (00-09 or DSS11~DSS20)
b2: Block 2 of Individual Speed Dial Codes (DSS1-10) (Digital phone only)
General:
This program divides sets of Individual Speed Dial into blocks for use by Stations.
Description:
z If in program 05-04-06, the Individual Speed Dial Codes are assigned:
500 sets, the maximum blocks in this program are 50 blocks.
400 sets, the maximum blocks in this program are 40 blocks.
300 sets, the maximum blocks in this program are 30 blocks.
z Each block has 10 sets of Individual Speed Dial.
z Each set has up to 30 digits.
z Speed Dial Codes 00~09 shares the same memory block with DSS11~DSS20.
z Each Station can use up to 2 blocks (20 sets of Individual Speed Dial.)
z If names are enabled in mode 05-05-05 then the number of blocks available is cut by half.
Example:
42-113-IP SPD-T
01 02
113: Station No. ( 2-4 digits )
01 02: Station 113 can use block 01 and 02 for Individual
Speed Dial (20 sets)
42-105-IP SPD-T
04 00
105: Station No. ( 2-4 digits )
04 00: Station 105 can use block 04 (10 sets) for Individual
Speed Dial (00-09 or DSS11~20), 00 : for no block.
42-118-IP SPD-T
00 03
118: Station No. ( 2-4 digits )
00 03: Station 118 can use block 03 for Individual Speed Dial
(DSS 1-10)
* Refer to Keyphone Operation
, G.04 for the programming of Individual Speed Dial.
* Be sure to program these parameters before programming speed dial on key phones.
If problems are encountered with stations not being able to program speed dial numbers, check this parameter
to be sure that speed dial locations are available to the station. If the station card was fitted at the time of system
initialisation then the blocks will have been allocated automatically.
default 111= 01 02
:
130= 39 40
05-04-06 0 1 2 3 4 5 6 7 8 9
05-05-05=0 No name 80, 70, 60, 50, 40, 30, 20, 10, 0, 0
05-05-05=1 With name 40, 30, 20, 10, 00, 00, 00, 00, 00, 00

Table of Contents

Related product manuals