G1E Programming Manual
141
04. Dial 9 trunk group/ SLT Port as MOH Source:
When a station selects a trunk line by dialling 9, the system finds an available trunk according to the dial 9 group
assignment. If a trunk is not in a stations assigned dial 9 group then the station will not be able to make outgoing
calls on that trunk.
0= use “Dial [87] trunk group” as “Dial 9 trunk group”. (see mode 46-ST-01).
That is, Dial 9 can access the “Dial [87] trunk group”. Using this setting can extend Dial 9 trunk
groups from 8 to 16.
1= search in the 1st tk group 2 = in 2nd tk group .…….. 8= in 8th tk group
If the Extension is an SLT port it can be used as an additional MOH input allowing individual tenants to each
have their own Message on Hold. The port is set to type 7 in Mode 43-port-02 then in Mode 41-slt-04 user can
allocate which trunk group will use this port as a MOH source. The current drawn from the SLT port MUST be
limited to no more than 10ma to prevent damage. A line isolator will achieve this.
0 = All Trunk groups 1-8 = Trunk group 1 to 8
Related System Programming Mode: 36, 38, 41-ST-04, 46-ST-01
05. Toll plan - Day:
This parameter assigns the toll plan to be used by the station in day mode.
Refer to Mode 18 for Toll plan details.
06. Toll plan - Night:
This parameter assigns the toll plan to be used by the station in night mode.
Refer to Mode 18 for Toll plan details.
07. Port number:
This is for checking only, the system will automatically show the correct port number. It is not possible for the
user to change or remove this parameter.
In the G1E, the port number consists of 2 digits
11~18: station ports on the G1E-MBU
21~28: station ports on the 1
st
G1E-STU or G1E-SLU card.
31~38: station ports on the 2
nd
G1E-STU or G1E-SLU card.
41~44: SLT station ports on MBU
To Next Page
Loading...
