130 Issue 3.3.2 / April, 2011
Program 35-tk-IP : Trunk Specifications – 1
35-tk-IP TK SPEC
0 1 0 0 3 0 0 0
tk = 01-12, IP = 01-08
System Default
Item Display
Pointer Data Programming Data Description Default
-------- ---------- ------------------------------------------------ -------------
01 0-1 Trunk Type 0=CO
02 0-1 Dialling Signal 1=DTMF
03 0-8 External Call Forward 0=No
04 0-8 DISA 0=No
05 0-3 Pick Up 3=Yes
06 0-9 Loud Bell 0=No
07 0-5 Inward Line Ringing Type - Day 0=Com
08 0-5 Inward Line Ringing Type - Night 0=Com
General:
This program permits every trunk line to be assigned different parameters.
Description:
01. Trunk Type:
0 = CO. = Trunk line is Central Office line.
1 = PABX. = Trunk line is installed behind a PABX or Centrex.
35-tk-01=1 incoming not delay ring (05-14-06) for paging trunk (G1E only).
02. Trunk Signal:
0 = Pulse = Trunk dialling signal is Dial Pulse.
1 = DTMF = Trunk dialling signal is DTMF (Touch-Tone).
03. External Call Forward - ECF:
0 = No ECF.
1 = ECF to system speed dial 101
2 = ECF to system speed dial 102
3 = ECF to system speed dial 103
4 = ECF to system speed dial 104
5 = ECF to system speed dial 105
6 = ECF to system speed dial 106
7 = ECF to system speed dial 107
8 = ECF to system speed dial 108
04. DISA/ECF (Direct Inward System Access/External Call Forward):
0 = Day - Disable Night - Disable
1 = Day - Disable Night - DISA Enable
2 = Day - DISA Enable Night - Disable
3 = Day - DISA Enable Night - DISA Enable
4 = Day - Disable Night - ECF Enable
5 = Day - ECF Enable Night - Disable
6 = Day - ECF Enable Night - ECF Enable
7 = Day - DISA Enable Night - ECF Enable
8 = Day - ECF Enable Night - DISA Enable
To Next Page
Loading...