G1E Programming Manual
135
Program 38-gp-tk : Dial 87 Trunk Group Assignments
38-gp-IP TK GRP
01 02 03 04 05
gp = 01-08, IP = 01-12
trunks to be included
General:
This program permits each trunk line to be assigned to different Trunk groups which can be accessed by dialling
[87]. There are 8 groups in total. This group will be available to a station in addition to or instead of it's dial 9
group. Always set outgoing calls to start from the highest fitted trunk and program in descending order to the
lowest trunk fitted. This will prevent call collision particularly in systems with SLT'S. Press [REDIAL] to clear all
entries in the table before entering required trunks.
Description:
This program is different from Program Mode 36-gp-tk. This program is used for dialling [87] or [9] to access a
Trunk Line.
Once a dial [87] group has been programmed it will need to be assigned to the stations that are to use it
in Mode 46-Stn-01.
Related System Programming Mode: 36, 38, 41-ST-04, 46-ST-01
To Next Page
Loading...
