HYBREX G1E - Program 05-10-Ip: System Timing Parameters - 10

80 Issue 3.3.2 / April, 2011
Program 05-10-IP : System Timing Parameters – 10
05-10-IP SYS PAR
d d d d d d d d
IP = 01-08
System Default.
Item Display Programming Data
Pointer Data Description Default
---------- ---------- -------------------------------------------------- ------------
01 0-9,*,# Leading Digit 1 For Voice Mail Forwarding d= None
02 HOLD Leading Digit 2 For Voice Mail Forwarding d= None
03 DND Leading Digit 3 For Voice Mail Forwarding d= None
04 Leading Digit 4 For Voice Mail Forwarding d= None
05 Leading Digit 5 For Voice Mail Forwarding d= None
06 Leading Digit 6 For Voice Mail Forwarding d= None
07 Leading Digit 7 For Voice Mail Forwarding d= None
08 Leading Digit 8 For Voice Mail Forwarding d= None
Description:
This parameter allows the system to insert digits before the call forwarded station number when the call
forward is received by the voice mail port if Standard Protocol is selected. If the station numbering is only
2 or 3 digits the system will insert additional digits if the Voice Mail requires more. The last digits of the
voice mail box number will still have to be the same as the station numbering for correct recognition. The
HOLD key can be used to insert a pause in the DTMF tone sending and will display as a (p). The DND
key is no digits sent and is shown as (d).
Example:
The HYBREX is set to 2 digit numbering but the voice mail requires 4 digits. The voice mail also requires
a pause between answering the call and the tones being sent. Set this parameter to the following
05-10-IP SYS PAR
p 1 1 d d d d d
When the call forwarded station 11 is answered by the voice mail port after the pause time the digits
1111 will be sent to the port by the system. If station 11's voice mail box is 1111 then the mailbox
number 1111 will be automatically opened by the tones.
There are 2 different Voice Mail Protocols available in the HYBREX series depending on the setting in
Mode 05-12-05. If this mode is set to 0 then the Protocol will be the leading digits entered in this Mode
plus the Station Number of the forwarded station. If Mode 05-12-05 is set to 1 then the Enhanced
Protocol shown on the following page will be used.