78 Issue 3.3.2 / April, 2011
Program 05-09-IP : System Timing Parameters – 09
05-09-IP SYS PAR
0 1 0 0 0 1 5 2
IP = 01-08
System Default.
Item Display Programming Data Timing
Pointer Data Description Table Default
---------- ---------- -------------------------------------------------- ---------- ------------
01 0-1 Reserved 0=
02 0-1 Busy Console Queuing (Intercom Calls) 1=Enable
03 0-9 Clear Forward - Loop Disconnect Detection 0=Disable
04 0-9 DISA Busy Tone Detection 0=Disable
05 0- Reserved 0=
06 0-9 ACD-1 Enable Time O 1=10 Sec
07 0-9 ACD-1 Segment 2 Recall Time P 5=25
08 0-9 ACD-1 Release Time Q 2=10 min
Description:
01. Reserved
02. Console Queuing:
This feature enables the busy console(s) to have an intercom call(s) queued to it(them). If the station
dials the operator (by 0 or 9) and all the consoles are busy, the system will put this call in the queue to
wait for the operators to be free. The calling station will hear ring back tone instead of busy tone and the
first operator in the group will receive the Busy Remind Signal. The first operator to go on-hook will
receive the call.
0 = Disable 1 = Enable
03. Clear Forward Signal Detection - Loop Disconnect
This feature enables loop disconnection as a Clear Forward Signal.
0= Do not detect this signal.
1= The Loop Disconnecting Signal > 80 ms.
2= The Loop Disconnecting Signal > 130 ms.
3= The Loop Disconnecting Signal > 180 ms.
4= The Loop Disconnecting Signal > 230 ms.
5= The Loop Disconnecting Signal > 810 ms.
6= The Loop Disconnecting Signal > 860 ms.
7= The Loop Disconnecting Signal > 910 ms.
8= The Loop Disconnecting Signal > 960 ms.
9= The Loop Disconnecting Signal > 1010 ms.
04. DISA Busy Tone Detection:
This feature allows the system to recognize busy tone from the exchange line during DISA operation for
clearing down the call.
0 = Disable
1 = Australia busy tone (420 Hz, 375ms on/off)
(400 Hz, 375ms on/off)
2 = Italian busy tone (420 Hz, 500ms on/off)
To Next Page
Loading...