G1E Programming Manual
157
04. CTI-Extension Status Report:
Enabling this parameter will output the extensions status report for CTI applications. This parameter will need to
be enabled before CTI will work with this station.
0 = Disable 1 = Enable
05. VMS Leading Digits For Intercom Calls:
Enabling (disabling) this parameter allows the system to send (not send) the leading digit information of the
extension when making an intercom call to the voice mail. This allows the operator to transfer someone’s call
directly to the selected Voice mail box.
0 = Enable 1 = Disable
Related System Programming Mode: 05-12-05
06. . ACP Door Unlock Relay:
This parameter can select KSU relay or ACP relay as its Door unlock relay. If the MSC relay is enabled then
both the ACP relay and the MSC relay will operate for that doorphone. This will allow a more secure door
opening method when multiple ACP’S and Door unlocking are used.
0= Use ACP relay.
1= Use G1e-MSC Relay (mode 06-00 needs to be assign to ‘2’ ) and ACP relay
Related System Programming Mode: 05-12-04, 06
07. ACP Door Open Control
This parameter sets what action is required to open the door lock from an ACP / RFID phone.
0 = RF Proximity card OR Password 1 = RF Proximity Card AND Password.
08. ACP Phone Operation Type:
This parameter sets whether The ACP phone is used as a Door Phone or as a Wall Mounted Telephone
0 = Door Phone 1 = Wall Mounted Phone
To Next Page
Loading...
