HYBREX G1E - Program 46-stn-IP: Station Class of Service - 4; General; Description

150 Issue 3.3.2 / April, 2011
Program 46-stn-IP : Station Class of Service – 4
46-stn-IP STCOS
1 1 0 3 0 7 d 0
st = Station No. (2-4 digits) IP = 01-08
System Default
Item Display
Pointer Data Programming Data Description Default
---------- ---------- ----------------------------------------------------------- -----------
01 0-8 Dial [87] Trunk Group 1= 1
02 0-9 Send Message Wait Signal Level 0= 1
03 0-2 Automatic Answer Capability / Internal CLIP 0= No
04 0-7 DISA/ISDN Indial Recall Capability 3= Recall
05 0-9 Maximum Number Of Transfer Times Allowed 0= No Limit
06 0-7 Door Unlock/DND/CFWD Access 7= Yes
07 0-9 ACP Door Phone Hunt Grp./Permanent C/FW Grp. 0= d
08 0-7 SLT Ring Cadence Settings 0= Normal
General:
This program permits each station to be assigned to a different Class of Service.
Description:
01. Dial [87] Trunk Group:
If this setting is from 1 to 8, after the station dials [87] (or dials [9]), the system will automatically search for a free
line which is assigned in group 1 to 8 in Program Mode 38.
If the setting is 0, then no dial 87 group is available to this station.
Related System Programming Mode: 36, 38, 41-ST-04, 46-ST-01
02. Message Waiting Level:
The Stations assigned higher levels can leave message for stations with the same or lower levels. Ten levels (0-
9) are available (9=highest level, 0=lowest level). Stations which are set to 0 can not send a message wait and
can only receive a message wait from Stations which are class 9.
9 = Can do Message Waiting to Stations assigned level 0-9;
0 = Can not do Message Waiting (lowest level).
03. Automatic Answer Capability (Keyphone) / Internal CLIP(Caller ID) function:
For Digital Key Telephone:
This parameter if enabled will automatically switch on the microphone of the station if it receives an intercom call.
This setting is independent of whether the system is set to voice or ring signalling for intercom calls.
0 = No 1 = MIC permanently on. 2 = MIC will switch on for Intercom calls
For Single Line Telephone (Connected to G1E-SLU card or MBU SLT Port):
This enables system to send internal and external CLIP(Caller ID) signals to the single line telephone
0 = Disable CLIP
1 = Enable to send SDMF (number without name) CLIP to the single line telephone
5 & 6 = SLT displays CO Line number and CLIP