144 Issue 3.3.2 / April, 2011
Type 8 can be assigned to an analogue port to enable the system to send DTMF tones identifying a call
forwarded calls originating station. A voice Mail port will receive DTMF tones from call forwarded stations
identifying the mail box to which the call is intended. The mail box number must be the same as the station
number for this parameter to work although Mode 05-10 can insert leading digits before the station number is
sent to the Voice Mail and is also able to insert pauses before or during the string. There is also an Enhanced
Protocol to provide more information to the Voice Mail unit, see Mode 05-10 for descriptions of the protocols
available.
Type 9 allows the ISDN Basic Rate to be made an “S” bus
51~52: the 1st Internal ISDN port of the 1st G1E-SIU card, and the default extension number is 141~142
53~54: the 2nd Internal ISDN port of the st G1E-SIU card, and the default extension number is 143~144
55~56: the 3rd Internal ISDN port of the 1st G1E-SIU card, and the default extension number is 145~146
51~56: Virtual Station Port , and the default extension number is 141~146.
(Virtual station port pool same port with SIU S-interface)
Virtual Mailboxes
From Ver. E-53A The ISDN ports 51-56 are able to be allocated Voice Mail units to become Virtual mailboxes.
Virtual Mailboxes can then be programmed to Ring in Mode 01-02 and play a message that will be in effect a
DISA or AA message allowing multiple tenants on a G1E+ to have Auto attendant and each with there own
personal greeting message and the ability to tae messages. Virtual mailboxes can also be entered into a Hunt
Group and using the settings in Mode 29-tk-07/08 allow the ring assignment of a G1E+ to overflow to a virtual
mailbox for taking messages.
The Fax port will receive calls from trunks set to be Fax trunks in Mode 95-Tk-01 if a Fax CNG tone is present
when DISA answers the incoming call.
03. Flexible key pattern group assignments (DSS console):
This parameter assigns stations to one of 2 flexible DSS console key pattern groups.
0 = Disable 1-2 = Soft Key Plan 1 to 2
See Mode 08: Flexible DSS console key group assignment to write soft key plans.
04. Reserved:
05. Voice Mail Box Capacity-Virtual Mail box:
This parameter decides the total mail box message units which can be used by this extension and creates
Virtual Mailboxes. The G1E can have 6 virtual mailboxes on ports 51 to 56. These ports are shared with the
ISDN “S” bus and can be used for one use only per port.
00 = No mailbox 01 = 5 segments (150 to 600 secs range)
02 = 10 Segments (300 to 1200 secs range) 03 = 15 segments (450 to 1800 secs range)
04 = 20 Segments (600 to 2400 secs range) ………………………
Each unit has 30/60/120 seconds storage depending on CF card and Compression rate. Currently the largest
available CF card is 128Mb. The 1G card is a future release
CF Card
G1E-VMC (32kbps)(64Kbps for
1G) G1E-VMC (16kbps)
Total 1 Unit Duration Duration Total 1 Unit Duration Duration
Unit Duration (mins) (hours) Unit Duration (mins) (hours)
(secs) (secs)
128Mb 1000 30 Secs 500 8 1000 60 Secs 1000 16
1G 1000 60 1740 29
The total units may be reduced if more features are added to the VMU in the future.
To Next Page
Loading...
