G1E Programming Manual
129
04. Set Ring Frequency (DK handsets):
This feature allows each trunk to ring at DK handsets with its own individual ring frequency and override the
frequency set by the user for all calls.
0 = As per the key phone’s ring setting.
1~8 = Use the ringing frequency 1~8 of key phone as the trunk’s ring.
05. Allow Audible Ring for Incoming Calls:
This feature allows either some or all stations which are ring assigned in Mode 01 or 02 to receive the audible
ring signal when a trunk rings at the station. If the audible signal is disabled the station will still be able to answer
a call by lifting the handset only, if they are ring assigned in Mode 01 or 02
0 = All stations assigned in Mode 01 & 02 will receive audible signal for an incoming call
1 = Only the first station assigned in Mode 01 & 02 will receive audible signal for an incoming call. The
other ring assigned stations will still be able to answer a call by lifting the handset only
2 = The first 2 stations assigned in Mode 01 & 02 will receive audible signal for an incoming call.
The other ring assigned stations will still be able to answer a call by lifting the handset only
3 to 8............
9 = The first 9 stations assigned in Mode 01 & 02 will receive audible signal for an incoming call. The
other ring assigned stations will still be able to answer a call by lifting the handset only.
06. Polarity Reverse Detection – Individual trunk-Outgoing:
This parameter allows individual trunks to be enabled to detect Polarity Reverse on B party answer without
having to Enable all trunks system wide. This allows a system to have a mix of lines on one system and only
some of them will have reversal and some not. Mode 14-01-08 will enable system wide Reversal settings.
0= Disable 1 = Enable
07. CO Delayed Ring Timer to Hunting Group:
This parameter sets the delayed ring time for an incoming call to the hunting group. If the stations in the Ring
Assignment (mode 01/02) do not answer the incoming call within below timing, the call will overflow to the pre-
assigned hunting group (mode 29-TK-08). The Ring assigned stations will continue to ring.
0 = Disable 1 = 8 sec. 2 = 16 sec. 3 = 24 sec. 4 = 32 sec. 5 = 40 sec.
6 = 48 sec. 7 = 56 sec. 8 = 64 sec. 9 = 72 sec.
Related System Programming Mode: 29-Tk-07, 29-Tk-08, 67, 68, 69
08. CO Delayed Ring Overflow Hunting Group:
This parameter sets the pre-assigned overflow Hunting Group for an incoming call. If the stations in the Ringing
Line Preference Assignment (mode 01/02) do not answer the incoming call within the pre-assigned timing (mode
29-TK-07), the call will overflow to the pre-assigned hunting group.
0 = Overflow to Hunting Group 1
1 = Overflow to Hunting Group 2
2 = Overflow to Hunting Group 3
……
8 = Overflow to Hunting Group 9
9 = Overflow to Hunting Group 10
From Ver E53A the Hunt group can be programmed with a Virtual mailbox allowing incoming calls to overflow to
a mailbox if not answered. SeeMode43-51/56-05 to assign virtual mailboxes.
Related System Programming Mode: 29-Tk-07, 29-Tk-08, 67, 68, 69
To Next Page
Loading...