G1E Programming Manual
149
05. Intercom Calls to Different Station Groups:
If this function is disabled then stations will not be able to make intercom calls outside their own station group
(Mode 41-st-01). This parameter is for use in tenancy arrangements where each company wish's to remain
totally separate although some stations can still be allowed this function, for instance a shared Receptionist.
0 = Enable 1 = Disable
06. Receive Break Alarm:
If this parameter is disabled then the station will not receive the Break Alarm signal if one has been programmed
in Mode 39.
0 = Enabled 1 = Disable
07. Allow Unrestricted Speed Dial Access:
If this parameter is disabled then the station will not be able to access any of the Speed Dial numbers which
have been unrestricted in Mode 05-05-03/04 if they conflict with the stations toll restrictions.
0 = Enabled 1 = Disable
08. Record Station's SMDR Data (future):
If this parameter is disabled then calls to and from this station will not recorded or output to the SMDR for the
Mini Call Accounting feature. When the Mini Call Accounting feature is enabled (see Mode 14-01-08) then all
stations which are used for administration should have this feature disabled to prevent using memory
unnecessarily to record their calls. If calls are allowed to accumulate against stations which are not checked in or
out regularly then the system memory buffer will become full and calls will not be recorded.
0 = Record 1 = Do not Record
To Next Page
Loading...
