G1E Programming Manual
63
05. Busy Remind Cycle Time (Off-Hook Ringing):
This parameter selects the length of time an incoming trunk call rings the system before a busy ring
assigned station is reminded of the call. A muted, one-second ring will be given to the station through the
speaker to indicate the call. The tone will be repeated every busy remind time interval.
This parameter also sets the timing for the SLT Camp-On feature (see Mode 05-08-03 to extend timing
for SLT Camp on tone) and the camp on tone for key stations.
See timing table Grade C for parameters of this feature.
06. Pause Time:
This parameter sets the system pause time duration for speed dial entry, trunk access time and voice
mail call forwarding tone delay.
See timing table Grade D for parameters of this feature.
07. DTMF Generation Time:
This parameter permits the selection of DTMF Generation output time. The generation time may need to
be lengthened to access some Voice Mail or answering machines.
See timing table Grade E for parameters of this feature.
08. Call Forward No Answer Transfer Time:
This parameter sets the duration between calling a station which has set call forward no answer, and the
transfer of the call to the station to which it has been forwarded.
0 = 10 sec. 1 = 20 sec. 2 = 30 sec. ........... 9 = 100 sec.
TIMING TABLE
Grade 0 1 2 3 4 5 6 7 8 9 Unit
A 30 60 90 120 150 180 210 240 253
-
Sec.
C 0 2 4 6 8 15 30 60 120 254 Sec.
D 400 600 800 1000 1200 1400 1600 1800 2000 2200 ms.
E 48 64 80 100 114 132 156 164 180 196 ms.
To Next Page
Loading...