G1E Programming Manual
139
04. Station Loud Bell:
Refer to Program 06 to assign Relay to operate for a Loud Bell.
0 = No operation
1 = Operate relay on the MSC card when calls are received on this station.
The system does not provide any voltage from the assigned relay. A separate ring voltage and ring device will
need to be provided by the installer.
05. Access Paging:
0 = The "All Page" signal can be broadcast by this station.
1 = The "All Page" signal can not be broadcast by this station.
06. Receive Paging:
0 = The "All Page" signal can be received by this station.
1 = The "All Page" signal can not be received by this station.
This feature is useful for someone who should not be disturbed by paging calls.
07. Security code status:
0 = The station is unlocked. (Can make outgoing calls.)
1 = The station is locked. (Can not make outgoing calls.)
If a phone becomes locked accidentally or the user forgets their lock code, this parameter will unlock the phone.
There is no way of finding what the lock code was.
08. Forced account code:
There are 99 forced account codes which can be used on the system. Each user can be allocated use of one or
all of these. If a station has a Forced Account Code 01-99, the user can key [PRG][4] and the force account
code to override toll restrictions for one call only.
If the setting is from 01-99 then this Account Code ONLY can be used by the station. If the setting is 00 then the
station can use any one or all Account Codes.
Refer to Mode 17: Create Forced Account Code
To Next Page
Loading...
