G1E Programming Manual
17
Installation
Caution 1. This system should be installed by qualified service personnel.
2. Do not connect the Power Cord unless you have read the following
instructions and completed all the installation and wiring.
3. STATIC SENSITIVE DEVICES! Please handle with care.
Installing expansion and optional cards
In this step you will be installing printed circuit cards on to header pins of the main board in the basic
cabinet. Take your time and extra care to assure the printed circuit cards are properly aligned. After
installing each option and expansion card, perform a visual inspection to assure the printed circuit card
is installed properly.
1. Position the cabinet on a flat surface like a table or countertop. Avoid doing this on carpet.
2. Remove the screw located at the bottom of the cabinet and lift the front cover off.
3. Locate the expansion and option cards and unpack them at this time.
To Next Page
Loading...
