HYBREX G1E - Program 40-stn-IP: Station Class of Service - 1

138 Issue 3.3.2 / April, 2011
Program 40-stn-IP : Station Class of Service – 1
40-stn-IP STCOS
0 0 0 0 0 0 0 00
st = Extension NO.(2-4 digits). IP = 01-08
System Default
Item Display
Pointer Data Programming Data Description Default
---------- ---------- ----------------------------------------------------------------- -----------
01 0-9 Override Level 0= Not allowed
02 0-9 Monitor Level 0= Not allowed
03 0-9 Limit Call Duration 0=No
04 0-3 Station Loud Bell 0=No
05 0-1 Access Paging 0=Yes
06 0-1 Receive Paging 0=Yes
07 0-1 Security Code Status 0=None
08 00-99 Forced Account Code 00=All
General:
This programming Mode permits each station to be assigned a different Class of Service.
Description:
01. Override Level:
Higher level stations can override lower level stations, equal levels may override each other.
0 = Disable 1 = Lowest level 9 = Highest level
02. Monitor Level:
Higher level stations can monitor lower level stations, equal levels can not monitor each other.
0 = Disable 1 = Lowest level 9 = Highest level
03: Limit call duration:
Conversation will be interrupted by a Busy Tone. A warning tone will be given 10 seconds before the end of the
timed duration. (see Mode 05-04-03 to set call limiting action)
0 = No limit 1 = 3 min. 2 = 5 min. 3 = 10 min. 4 = 15 min. 5 = 20 min.
6 = 30 min. 7 = 40 min. 8 = 50 min. 9 = 60 min.
Related System Programming Mode: 05-04-03, 40-st-03