HYBREX G1E - Toll Restriction Override Prevention; Smdr Digit Mask; Meter Pulse Detect Delay Time; Reserved

G1E Programming Manual
75
05. Toll Restriction Override Prevention:
If the setting is Disable, after accessing a line a user will be able to use a DTMF generator directly to the
network rather than the DTMF signal generated within the KSU. The result of this is that Toll restrictions
can be over-ridden.
If setting is Enable, then no audio will be sent from the handset until 3 digits are received by the KSU
from the key station dial pad preventing Toll restrictions being overridden. This parameter will be
automatically disabled on any lines which are set to Pulse dial.
0 = Disable 1 = Enable
06. SMDR Digit Mask:
If setting is "0", then the full length of the telephone number will be output to the SMDR. If setting is n,
then the length of the telephone number will be n digits long.
n = 0 to 9
07. Meter Pulse Detect Delay Time (CO release guard time):
This parameter is also used to insert a pause between a line being released and being able to be re-
selected for outward dialling.
See timing table grade K for parameters for this feature.
08. Reserved
TIMING TABLE
Grade 0 1 2 3 4 5 6 7 8 9 unit
K 0 1 2 3 4 5 6 7 8 9 sec.