G1E Programming Manual
51
VMU Setup
The G1E MBU contains an on board 4 Channel Auto Attendant with voice messaging. Also included is a
2 minute MOH section. In Default the MOH is pre-recorded with Auto Telecom’s copyright free music.
The optional VMU card contains a 4 channel Voice Mail / Auto Attendant which when installed on the
G1E-MBU will remove the Auto Attendant feature from the MBU and assign it to the VMU.
Messages recorded on the MBU AA will be replaced by messages recorded on the VMU card.
Messages are recorded in Flash Ram and do not require any battery backup to maintain.
Program Mode 25 provides a copy function that allows the G1E to automatically copy messages from
the MBU flash to the VMU Flash or from the VMU Flash to the MBU Flash.
For a description of this procedure see mode 25 in the Programming manual
To access the MBU Flash Ram to setup or record messages dial 8901 from the Console.
To access the VMU Flash Ram to setup or record messages dial 8902 from the Console.
Internal Music on Hold Source
The G1E and G1E+ have a 2 Minute MOH message recorded on the MBU Flash ram. This message
can be recorded by the customer to allow them to use their own message or an SLT port can be used to
connect multiple external Music sources if required.
External Music on Hold Source – G1E
The G1E system does not have an external Music port but relies on using the 2 Minute MOH message
recorded on the MBU Flash ram. This message can be recorded by the customer to allow them to use
their own message or an SLT port can be used to connect an external Music source if required.
1.
Connect music source to SLT Port via Line isolator.
2.
Set 43-SLT PORT-02=7
2. 05-08-08=4 or 5 ( 4= BGM uses Internal music, 5=BGM uses SLT music; MOH uses SLT music
port).
To Next Page
Loading...