74 Issue 3.3.2 / April, 2011
Program 05-07-IP : System Timing Parameters – 07
05-07-IP SYS PAR
0 0 0 0 0 0 0 0
IP = 01-08
System Default.
Item Display Timing
Pointer Data Programming Data Description Table Default
---------- ---------- -------------------------------------------------- ------------- -------------
01 0-1 Intercom Searching 0=Disable
02 0-1 Toll Override Prevention from quick dial 0=Disable
03 0-1 Paging Alert Tone 0=Enable
04 0-7 DISA Transfer To Console - No Dialling 0=Enable
05 0-1 Keyphone Toll Override Prevention 0=Disable
06 0-9 SMDR Digit Mask 0=Disable
07 0-9 Meter Pulse Detect Delay Time 0=0 Ms.
08 0- Reserved 0=
Description:
01. Intercom Searching:
If setting is enable, when calling an internal station which is busy or does not answer, pressing [4] will
call the next station which is in the same station group as the called station. If setting is disable then
there will be no transfer.
0 = Disable 1 = Enable when busy
2 = Enable when no answer 3 = Enable when busy or no answer
02. Toll Override Prevention from quick dial:
To protect toll override control when a Key phone selects a trunk and quickly dials one digit and
overriding the toll control. If Enabled then after selecting a trunk the first digit dialled will be delayed one
pause interval.
0 = Disable 1 = Enable
03. Paging Alert Tone:
This parameter enables/disables the paging alert tone.
0 = Enable page alert tone =1 Disable page alert tone
04. DISA Recall To Console - No Dialling:
If this function is activated, when a DISA call is answered but the caller does not dial any digits or a
station number the system will recall the Operator after the assigned DISA Transfer Time no dialling
(Mode 05-08-07). If this function is disabled the call will be disconnected after Transfer Time No Dialling
elapses.
This parameter also is used to clear the VMU channels after 10 minutes of operation where problems
are found with locked up VMU channels.
0 = Recall To Operator 1 = No Recall To Operator
To Next Page
Loading...