HYBREX G1E - Program 05-18-Ip: System Timing Parameters - 18; Led Maintenance; Reserved; Dial out History Feature

96 Issue 3.3.2 / April, 2011
Program 05-18-IP : System Timing Parameters – 18
05-18-IP SYS PAR
0 0 0 0 0 0 8 5
IP = 01-08
System Default.
Item Display Programming Data Timing
Pointer Data Description Table Default
---------- ---------- ----------------------------------------------------------- ---------- ------------
01 0- Led Maintenance 0= Disable
02 0- Reserved 0=
03 0-1 Dial out History Feature 0=Disable
04 0- FSK Standard for Caller ID 0= Bellcore
05 0-9 Security alarm and fire alarm stop timer 0= No limit
06 0-1 Play Transfer message for ECF 0=
07 0-9 High Frequency Level of DTMF Generator
0=
08 0-9 Low Frequency Level of DTMF Generator
0=
Description:
01. LED Maintenance:
This parameter sets the LED maintenance feature. The LED Maintenance feature checks that the status
of LED’s is correct and no indications are lost.
0 = Disable 1 = Enable
02. Reserved:
03. Dial Out History Feature:
This parameter enables a dial out history memory buffer. When this feature is enabled the user can
press [Redial] and using the Up/down volume keys can scroll through the last 10 dialled out numbers
and then by pressing the [SPK] key dial any of the numbers.
Each phone has 2 blocks available, when this feature is enabled Block A will be used for CLI numbers
and Block B will be used for Dial out History.
0 = Disable 1 = Enable
04. FSK Standard For Caller ID:
This parameter selects between Bellcore/Etsi standard and Stentor Canadian Standard.
0 = Bellcore 1 = Stentor