HYBREX G1E - Program 45-Stn-Ip: Station Class of Service - 3

148 Issue 3.3.2 / April, 2011
Program 45-stn-IP : Station Class of Service – 3
45-stn-IP STCOS
0 0 0 0 0 0 0 0
st = Station No. (2-4 digits) IP = 01-08
System Default
Item Display
Pointer Data Programming Data Description Default
---------- ---------- ----------------------------------------------------------- -------------
01 0-1 Intercom Call Limitation 0=Disable
02 0- LMS hear BGM at idle state 0=No
03 0- Ring increase 0=No
04 0-1 Allow Trunk Access 0=Yes
05 0-1 Intercom Calls To Different Station Groups 0=Yes
06 0-1 Receive Break Alarm 0=Yes
07 0-1 Allow Unrestricted Speed Dial 0=Yes
08 0-1 Record Station's SMDR Data 0=Yes
General:
This program permits each station to be assigned to a different Class of Service.
Description:
01. Intercom Call Limitation:
If this setting is enabled, the station can not make an intercom call by dialling a station number. Under this
condition, the Key Phone still can press a Flexible Key to make an intercom call or the Key Station or Analogue
phones can call a station using the "Single Digit" feature.
0 = Disable 1 = Enable
02. ACP Hear BGM at idle state:
0=disable 1=enable
03. Ring Increase
This parameter will enable the Ring Volume of an incoming trunk to increase over time if not answered on this
extension.
0 = Disable 1 = Enable
04. Allow Trunk Access:
If this function is disabled then the station will be unable to access any trunks for incoming or outgoing calls.
0 = Enable 1 = Disable