HYBREX G1E - Program 78-Stn-Ip: Station Class of Service - 6

170 Issue 3.3.2 / April, 2011
Program 78-stn-IP : Station Class of Service – 6
78-stn-IP STCOS
0 0 0 0 0 0 0 0
st = Station No. (2-4 digits) IP = 01-08
System Default
Item Display
Pointer Data Programming Data Description Default
---------- ---------- ----------------------------------------------------------- -----------
01 0-5 LCR - Routing Level 0= Disable LCR
02 0-1 LCR – Direct Access a Trunk 0= Not Allowed
03 0- Reserved 0=
04 0-9 Call Forward Busy Transfer Group 0= None
05 0-1 External Notification – Voicemail 0=Disable
06 0-9 Calling Line Identification Presentation 0=Mode 72
07 0-1 Ring Line Preference 0=Disable
08 0- Reserved 0=
Description:
01. LCR Routing Level
This parameter assigns the LCR routing level for each station.
0 = Disable LCR.
1 = Allow this station to use the 1
st
priority trunk group only.
2 = Allow this station to use the 1
st
and the 2
nd
priority trunk groups only.
3 = Allow this station to use the 1
st
~3
rd
priority trunk groups only.
4 = Allow this station to use the 1
st
~4
th
priority trunk groups.
5 = Allow this station to use the 1
st
~4
th
priority trunk groups. If there are no available trunks in the 1
st
~4
th
priority
trunk groups, the system will allow this station to use normal dialling.
Related system Programming: 05-13-07. 05-13-08, 75, 76, 77, 78-st-01, 78-st-02
02. LCR – Direct Access a Trunk
This parameter assigns the right of the station to select a trunk directly when LCR is enabled.
0 = Do not allow to access a trunk direct (need to dial 9 (or 0) first).
1 = Allow this station to access a trunk direct (by pressing line key button). System will assign any pre-
assigned idle trunk for this extension.
2 = Allow this station to access a trunk direct (by pressing line key button). System will assign any
dedicated idle trunk for this extension. Stations which have this facility enabled can only, access trunks,
which are in their own trunk group set in 41-STN-04. LCR Routing will still apply for the calls but if the
LCR route (mode 76) has the trunk group set to 0 which means use station trunk group.
Related system Programming: 05-13-07. 05-13-08, 75, 76, 77, 78-st-01, 78-st-02
03. Reserved: