146 Issue 3.3.2 / April, 2011
Program 44-stn-IP : Station Class of Service – 2
44-stn-IP STCOS
0 0 0 0 1 0 0 0
st = Station No. (2-4 digits) IP = 01-08
System Default
Item Display
Pointer Data Programming Data Description Default
---------- ----------- ----------------------------------------------------------- ----------
01 0-1 System Alarm 0=Enable
02 0-1 Hold feature 0=Enable
03 0-1 Call Split 0=Enable
04 0-1 Manual Line 0=No
05 0-1 Headset feature 1=Enable
06 0-1 Use Engineering Password 0=Enable
07 0-1 DTMF Receiver Control for Voice mail Ports 0=Normal Timeout.
08 0-1 Station Alarm Signal Type 0=Music
General:
This program permits each station to be assigned to a different Class of Service.
Description:
01. System Alarm:
If the setting is disable, the station will not receive system alarm clock signals.
0 = The "System Alarm" signal will be received on this station.
1 = The "System Alarm" signal will not be received on this station.
02. Hold feature:
If the setting is disable, the station will not be able to place calls on hold.
0 = Hold function allowed
1 = Hold function not allowed
03. Call Split:
If the setting is disable, the station will not be able to activate call splitting function. When activated and the
station presses hook flash after placing a call on hold the call will not be retrieved. Dialling 9 (or 0) or 72 will
retrieve the held call.
0 = Call Splitting function allowed
1 = Call Splitting function not allowed
Related System Programming Mode: 07(code 26), 44-st-03
To Next Page
Loading...
