Refer to Coolant-hose assemblies (cooler to plasma power supply)
on page 425 for lenghts and part numbers.
a. Connect the coolant-return hose with the red band to the red coolant-return fitting.
b. Connect the coolant-supply hose with the green band to the green coolant-supply fitting.
2. Connect the coolant-hose assembly to the cooler from the gas connect console:
Refer to Coolant-hose assemblies (cooler to gas connect console)
on page 425 for lengths and part numbers.
a. Connect the coolant-return hose with the red band to the red coolant-return fitting.
b. Connect the coolant-supply hose with the green band to the green coolant-supply fitting.
3. Connect the female cable connector on the 220 VAC power cable to the cooler from the plasma
power supply.
Use your fingers to tighten these connections, do not use tools.
Refer to Power cables, 220 VAC on page 424 for lengths and part
numbers.
4. Connect both CAN cables:
Use your fingers to tighten these connections, do not use tools.
Refer to CAN cables on page 425 for lengths and part numbers.
a. Connect the male cable connector on one CAN cable to the cooler from the gas connect
console.
b. Connect the female cable connector on the other CAN cable to the cooler from the plasma
power supply.
Installation
3
113811530Instruction ManualXPR460
To Next Page
Loading...
