h. Put the assembly coupler on the console collar and tighten the hose clamp.
2. Connect the pilot-arc, coolant, and shield-water assembly to the TorchConnect console:
a. Put the pilot-arc, coolant, and shield-water assembly through the console collar on the
TorchConnect console.
b. Put the shield-water hose connector in the push-to-connect fitting, push until it stops,
approximately 13 mm (0.5 inch).
c. Connect the coolant-return hose with the red bands to the coolant-return fitting with the red
band.
d. Connect the coolant supply hose with the green bands to the coolant-supply fitting with the
green band.
e. Connect the pilot-arc cable.
Installation
3
125811530Instruction ManualXPR460
To Next Page
Loading...
