NOTICE
INCORRECT SUPPLY-GAS CONNECTIONS CAN CAUSE BAD PERFORMANCE
Cutting system performance can be bad if a supply-gas hose is connected to the wrong port on a
gas connect console.
NEVER connect a supply gas to a hose, connection, or fitting that is not designed for that gas type
or pressure.
NOTICE
DIRTY, OILY AIR CAN CAUSE DAMAGE TO THE AIR FILTER BOWL
Some air compressors use synthetic lubricants that contain esters. Esters can damage the
polycarbonates in the air filter bowl.
Add additional gas filtration if necessary.
NOTICE
INCORRECT GAS PRESSURES CAN CAUSE BAD PERFORMANCE
Gas leaks or pressure and flow rates that are outside of recommended ranges can cause problems
with system performance, result in bad cut quality, and shorten the life of consumables.
If the quality of the gas is bad or if the pressure setting is incorrect, it can decrease cut quality, cut
speed, and cut thickness capabilities.
Make sure the incoming gas pressure aligns with system specifications.
As an installer or user, you must supply these items for your cutting system:
■
High-quality gas regulators
■
Supply gas plumbing
■
Supply gases
The items that you supply must comply with all minimum requirements
and must be installed by an approved technician.
Installation
3
131811530Instruction ManualXPR460
To Next Page
Loading...
