d. After you install the coolant-return hose, fully tighten the pilot arc and ohmic cable connectors.
Use your fingers to tighten the connection, do not use tools.
e. Connect the plasma valve.
Use your fingers to tighten the connection, do not use tools.
f. Push the Plasma Line A hose in the connector until it stops, approximately 13 mm (0.5 inch).
This is a push-to-connect fitting. Make sure the hose is fully inserted and the insertion mark is
no longer visible.
Installation
3
138
811530 Instruction Manual XPR460
To Next Page
Loading...
