g. Push the coolant-supply hose in the connector until it stops, approximately 13 mm (0.5 inch).
This is a push-to-connect fitting. Make sure the hose is fully inserted and the insertion mark is
no longer visible.
h. Push the shield-gas hose in the connector until it stops, approximately 13 mm (0.5 inch).
This is a push-to-connect fitting. Make sure the hose is fully inserted and the insertion mark is
no longer visible.
i. Push the Plasma Line B hose in the connector until it stops, approximately 13 mm (0.5 inch) .
This is a push-to-connect fitting. Make sure the hose is fully inserted and the insertion mark is
no longer visible.
Installation
3
139811530Instruction ManualXPR460
To Next Page
Loading...
