6. Install the torch mounting sleeve:
a. Move the torch mounting sleeve in the direction of the torch.
b. Use your hands to tighten the torch mounting sleeve connection.
A spanner wrench is included in all of the consumable parts
kits. Refer to Consumable starter kits on page 420. Do not
overtighten the torch mounting sleeve if you use the spanner
wrench to keep the torch stable during installation of the
mounting sleeve.
7. Put the collar in the correct position on the torch-end of the torch lead:
a. Move the collar in the direction of the torch-end of the torch-lead assembly.
Installation
3
140
811530 Instruction Manual XPR460
To Next Page
Loading...
