IBM i 830

Reference
Code
Description/Action Perform all actions before exchanging
Failing Items
Failing Item Location
0650 Resource management segment could not be created or
extended
A main store dump was initiated.
Words 2 to 9 of this SRC contain additional diagnostic
information. Record SRC words 1 through 9.
Perform a system IPL and collect the Product activity log and
mainstore dump and provide them along with the recorded
SRC information to IBM Service Support.
The problem may also be that there is not enough auxiliary
storage.
AJDG301
0801 Invalid LID directory detected
During system IPL, the LIDMgr detected an I/O failure or
media failure while trying to read the LID directory.
Perform “LIC-PIP8” on page 349.
FI00070
FI00300
AJDG301
0802 LID directory unusable
During system IPL, the LIDMgr detected that the LID directory
and associated load source is not usable.
Reinstall the Licensed Internal Code using “Licensed Internal
Code Install and Restore” in the iSeries Service Functions
information.
For more information, contact IBM Service Support.
AJDG301
0901 The LinkLoader has found its bad flag ON
This reference code is usually the result of a system termination
while the LinkLoader is performing its work.
Reinstall the Licensed Internal Code using “Licensed Internal
Code Install and Restore” in the iSeries Service Functions
information.
0902 Unable to perform programmed IPL
The LinkLoader was not successful in performing a
programmed IPL.
Perform a system IPL. If the problem persists, examine the
main storage dump and determine the reason for the failure of
the programmed IPL.
1001 Enqueuing a task to the TDQ which is already enqueued on
TDQ
Perform “LIC-PIP8” on page 349.
AJDG301
1103 MISR not readable; must be readable for Normal Mode install
MISR is not readable. Perform a manual install to reinitialize
the system.
B6xx (including A6xx)
244
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1