6-33
SECTION 6
OPTIONS
6-12-7 TRANSMIT TRUNKING DATA BLOCK
The Transmit Trunking Data Block is used to set the Mobile Radio paramaters that are
passed to the Repeater.
This information, as well as the Channel Number (1) and Band Selection are required to
test a Repeater.
23. In Use
Displays Repeater Number used by Mobile
Radio. Displays 31 at message end to
signify end of transmission. Range is 1 to
31.
24. Group
Displays ID Code for Mobile Radio
serviced by Repeater. Range is 1 to 255.
25. PTT
Displays Push-To-Talk Status passed to Repeater. Displays ON or OFF. Push-
To-Talk Status is toggled by pressing START/STOP CONTROL Key or use the
MIC Accessory PTT.
26. Free
Not used by Mobile Radios. Field is editable, but should contain 31 for normal
operation. Range is 1 to 31.
27. Home
Displays Home Repeater Number for Mobile Radio. Range is 1 to 31.
28. Area
Displays Proximity Switch setting. Range is 1 or 0.
00607240
Group
In UseArea
Home
Free
151
9
0
5
31 PTT
23
24
26
27
28
25
ON
To Next Page
Loading...
General