1-10
SECTION 1
INTRODUCTION
1-9 OPTIONS
Option 01 – Internal Battery
Provides self-contained dc power when
external ac or dc power is unavailable.
Option 02 – 0.01 OCXO
Replaces the standard TCXO as system
time base. Provides 0.01 x 10
6
accuracy.
Option 03 – 30 kHz IF Filter
This option provides additional band
limiting between 15 kHz and 300 kHz
offered in a standard set.
Option 04 – Variable Audio Generator 2
Replaces standard fixed 1 kHz Audio
Generator with variable frequency Audio
Generator.
Option 05 – Generate Amplifier
Internal RF Amplifier providing 26 dB
gain for additional RF output.
Option 07 – Data Generator/Bit Error
Rate (BER) Meter
This option provides testing for digital
characteristics of transceivers.
Option 08 – SSB Receive Filter
This option provides ability to monitor
SSB signals.
Option 09 – RCC Signaling
This option provides 10 PS, 20 PS, MTS,
IMTS and Tone Remote Control
signaling.
Option 11 – Audio/Digital Signaling
This option provides encode/ decode
capabilities for the formats: CCIR,
CCIRH, CCIRH4, EEA, EIA, NATEL,
ZVEI, DZVEI, DDZVEI, EURO, 5/6 Tone
and POCSAG.
Option 12 - Tracking Generator
This option provides internal Tracking
Generator for use with Spectrum
Analyzer.
Option 13 - IEEE 488 (GPIB) Interface
This option provides parallel GPIB
interface for remote operation.
Option 14 - CLEARCHANNEL LTR
Simulates the CLEARCHANNEL LTR
repeater system. CLEARCHANNEL LTR
is a Registered Trademark of E. F.
Johnson.
Option 15 - AMPS Mobile Station Test
Auto and manual test to verify operation
of AMPS mobiles, transportables and
portables.
Option 16 - EDACS
Provides test capability for EDACS
repeaters and mobiles
To Next Page
Loading...
General