C-1
APPENDIX C - REPACKING FOR SHIPPING
C-1 SHIPPING INFORMATION
IFR Test Sets returned to factory for calibration, service or repair must be repackaged and
shipped subject to the following conditions:
C-1-1 AUTHORIZATION
Do not return any products to factory without authorization from IFR Customer Service
Department.
CONTACT:IFR
Customer Service Dept.
10200 West York Street
Wichita, Kansas 67215
Telephone: (800) 835-2350)
FAX: (316) 524-2623
C-1-2 TAGGING TEST SETS
All test sets must be tagged with:
•
Owner’s identification and address.
•
Nature of service or repair required.
•
Model No. and Serial No.
C-1-3 SHIPPING CONTAINERS
Test Sets must be repackaged in original shipping containers using IFR packing materials. If
original shipping containers and materials are not available, contact IFR Customer Service
Department for shipping instructions.
C-1-4 FREIGHT COSTS
All freight costs on non-warranty shipments are assumed by the customer. (See “Warranty
Packet” for freight charge policy on warranty claims.)
C-2 REPACKING PROCEDURE
•
Make sure bottom packing mold is seated on floor of shipping container.
•
Adjust handle to lay unlocked against Test Set as shown.
•
Place Elastic Retainer around Test Set to secure handle.
•
Carefully wrap Test Set with polyethylene sheeting.
•
Place Test Set into shipping container, making sure Test Set is securely seated in bottom
packing mold.
•
Place top packing mold over top of Test Set and press down until mold rests solidly on bottom
packing mold.
To Next Page
Loading...
General