EasyManuals Logo

IFR COM-120C User Manual

IFR COM-120C
326 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #234 background imageLoading...
Page #234 background image
6-59
SECTION 6
OPTIONS
6-13-7 MOBILE INIT TEST
The Mobile Init (Initiated) Test requires a call to be initiated from the Mobile Phone.
The following procedure performs the Mobile Init (Initiated) Test:
o With cursor on Mobile Init, press F2 ENABLED=. Press F3 START to start test.
o
“Place Call” prompt appears. Place call using Mobile Phone under test.
o
“Enter Digits” prompt appears. Enter up to 16 digits using Mobile Phone to test
DTMF transmission. Pressing F1 Cont continues Mobile Init Test with or without
digits entered.
o
“Press Flash Hook” prompt appears. Send Flash Hook signal using Mobile Phone.
Pressing F1 Cont continues Mobile Init Test without testing Flash Hook message.
o
“Measuring Frequency” message appears indicating Maintenance Order is sent to
the Mobile Phone for measuring Signal Tone frequency.
o
“Press Flash Hook” prompt appears. Send Flash Hook signal using Mobile Phone.
“Hangup Phone” prompt appears. Hang up Mobile Phone or press F5 Release for
release order to be sent to Mobile Phone. When “Hangup Phone” prompt
disappears, Mobile Init Test is finished.
o
Power Level Test is performed with the Mobile Init Test. After testing is finished,
press F2 Results to page through results. Mobile Init Test results resemble the
example.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IFR COM-120C and is the answer not in the manual?

IFR COM-120C Specifications

General IconGeneral
BrandIFR
ModelCOM-120C
CategoryMonitor
LanguageEnglish