6-112
SECTION 6
OPTIONS
6-15-12 TEST EXECUTION
During test execution, the Repeater Simulator screen is displayed. Editing of fields is
not permitted in this mode. Autotest status and user prompts are displayed in the title
bar at the top of the screen, or in pop-up windows.
Note that before the selected tests are executed, a control channel acquisition test is
always performed. Pressing any hard-key aborts the autotest.
Once the sequence of tests has been completed, the auto test selection/results screen
is re-displayed. This screen indicates the overall result and result for each test:
"PASS", "FAIL" or "----" (not tested). These results are based on both protocol and
parametric checks.
To Next Page
Loading...
General