6-113
SECTION 6
OPTIONS
6-15-13 PARAMETRIC RESULTS
The Parametric Measurements Screen for the Automated Test Mode displays the
measured values, together with pass/fail results for each measurement based on the
limits table. The result for each test is indicated as: "PASS", "FAIL" or "----" (not
tested).
1. Tx
Freq Error
Measured value of transmitter frequency error, in kHz.
2. Tx Power
Measured value of transmitter power, in W.
3. Tx Deviation
Measured value of transmitter deviation, in kHz.
4. Tx
Limiter
Measured value of transmitter limiting deviation, in kHz.
5. Tx Distortion
Measured value of transmitter distortion, as a percentage.
6. Rx Sensitivity
Measured value of Receiver Sensitivity, in dBm or µV.
7. Rx
SINAD
Measured value of receiver SINAD, in dB.
8. Rx Distortion
Measured value of receiver distortion, as a percentage.
9. Rx AF Level
Measured value of receiver audio level, in Vrms.
To Next Page
General