6-109
SECTION 6
OPTIONS
9. Speech Call to RU
This test attempts to set up a speech call to the Radio Unit. Transmit and receive
parametric measurements are then taken, subject to the correct audio connections
between the RU and COM-120C.
If direct audio connection is not available, choose to SKIP the receiver
parametrics test when at the prompt.
The call is cleared from the COM-120C.
10. Handoff
This test sets up a speech call to the Radio Unit. Once in traffic, the RU is
handed off to the lowest channel specified in the network definition. Parametric
measurements are performed as per SPEECH CALL TO RU. The call is cleared
by the COM-120C, which then calls the RU again and hands it off to the highest
channel. The parametric measurements are repeated on this channel. Finally,
the COM-120C clears the call and ensures the RU returns to the control channel.
To Next Page
Loading...
General