EasyManua.ls Logo

IFR COM-120C - Page 315

IFR COM-120C
326 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Index-2
G
General Characteristics (specifications) 1-23
General Duplex Generate Operation 4-54
General Duplex Receive Operation 4-59
General (introduction) 1-1
General (installation) 2-1
General RF Generate Operation 4-1
General RF Receive Operation 4-31
Generate Amplifier (Option 05) 6-1
Generating AM Modulated RF Signal 5-4
Generating DCS Coded RF Signal 5-8
Generating DTMF Coded RF Signal 5-10
Generating FM Modulated RF Signal 5-2
Generating Microphone Modulated RF Signal 5-14
Generating PM Modulated RF Signal 5-6
Generating RF Signal Using External Modulation 5-12
H
Handoff Test 6-57
I
Independent Audio/Data Signaling Generators 4-63
Independent Oscilloscope Operation 4-62
Independent Spectrum Analyzer Operation 4-62
IEEE 488 (GPIB) Interface (Option 13) 6-20
Configuring For Remote Operations w/GPIB 6-20
General 6-20
Input/Output Connectors (specifications) 1-22
Internal Battery (Option 01) 6-1
L
LTR Radio Handoff Test 6-41
LTR Radio Handshake Test 6-40
LTR Radio Receive Test 6-42
LTR Repeater Handshake Test 6-45
LTR Trunking Auxiliary Setup Screen 6-35
LTR Trunking Radio Simulation 6-29
LTR Trunking Repeater Simulation 6-23
M
Making Selections From Menus 3-11
Master Oscillator (specifications) 1-22
Memory Lists and Storage of Parameters 3-26
Meters 1-9
Meters Operation 4-69
Meter Screens 3-25
Mobile Init Test 6-59, 6-64
Modulating RF Signals w/Digital
Signaling Formats 6-13
Modulation (specifications) 1-12
MPT1327/MPT1343 Numbering Schemes 6-106
MPT1327 Trunking (Option 17) 6-96
O
Off-Air Monitor 6-114
Options 1-10
Oscilloscope 1-6
Oscilloscope Operation Screen 4-20, 4-53
Oscilloscope (specifications) 1-20
Oscilloscope Screen 3-20
Oven Crystal Oscillator Frequency Standard
(Option 02) 6-1
P
Parametric Limits 6-110
Parametric Results 6-113
Phase Modulation Meter Operation 4-43
Power Requirements (specifications) 1-22
Power Source Requirement Page-1
Power Up Procedures 2-3
Precautions (installation) 2-1
R
Radio Simulator 6-107
Radio Simulator Operation 6-43
RCC Signaling Formats (Option 09) 6-10
Rear Panel Controls 3-7
Receiver (specifications) 1-15
Receive Data Configuration Section 6-6
Received Level Meter Operation 4-47
Receive Level Meter (specifications) 1-19
Receive Trunking Data Block 6-28, 6-34
Receiving AM Modulated RF Signal 5-22
Receiving FM Modulated RF Signal 5-20
Receiving PM Modulated RF Signal 5-24
Registration Test 6-53, 6-63
Repacking For Shipping C-1
Repeater Simulator 6-104
Repeater Simulator Operation 6-38
RF Frequency Error Meter Operation 4-49
RF Frequency Error Meter (specifications) 1-16
RF Generate 5-1
RF Generate Operation 1-2, 4-1
RF Generate Screen 3-12
RF Power Meter Operation 4-45
RF Power Meter (specifications) 1-18
RF Receive 5-19
RF Receive Operation 1-3, 4-31
RF Receive Screen 3-14
RF Signal Generator (specifications) 1-11

Table of Contents