4-17
SECTION 4
OPERATION
If Peak Hold Function is desired, take
meter out of Autorange and configure as
follows:
OFF/ON
Toggles Peak Hold Function ON or OFF.
RST PK
Resets Peak Hold Function.
If Average Function is desired, configure
as follows:
OFF/ON
Toggles Average Function ON or OFF.
Cursor to Sample Number to enter
desired value. Range is 2 to 10.
If Upper Limit Function is desired,
configure as follows:
OFF/ON
Toggles Upper Limit Function ON or
OFF. Enter Limit Value. Range is 0.0 to
100.0%.
If Lower Limit Function is desired,
configure as follows:
OFF/ON
Toggles Lower Limit Function ON or
OFF. Enter Limit Value. Range is 0.0 to
100.0%.
If Alarm Function is desired, configure as
follows:
OFF/ON
Toggles Alarm Function ON or OFF.
When activated, alarm alerts over range
condition.
RETURN
Returns to RF Generate Operation
Screen.
Peak Hold:
Average:
ON
ON 2
Upper Limit:
Lower Limit:
ON
ON
5.0%
10.0%
Lower Limit:
Alarm:
ON
OFF
5.0%
Lower Limit:
Alarm:
ON
OFF
5.0%
Average:
Upper Limit:
ON
ON 28.0
2
10.0%
To Next Page
Loading...
General