Table 45: AC Power Supply Specifications for an EX4550 Switch (continued)
SpecificationItem
1375 BTU/HourSystem Thermal Output of EX4550-32T switches with two
EX4550-EM-8XT expansion modules installed = (MaximumSystem Power
Requirement ) * 3.41
NOTE: 1 W = 3.41 BTU/Hour
•
When operating in normal speed—4.8 W
•
When operating in high speed—16.8 W
Power required by each fan module
Related
Documentation
AC Power Supply in EX4550 Switches on page 41•
• AC Power Supply LEDs in EX4550 Switches on page 43
AC Power Cord Specifications for an EX4550 Switch
A detachable AC power cord is supplied with the AC power supplies. The coupler is type
C13 as described by International Electrotechnical Commission (IEC) standard 60320.
The plug at the male end of the power cord fits into the power source outlet that is
standard for your geographical location.
NOTE: In North America, AC power cords must not exceed 4.5 meters
(approximately 14.75 feet) in length, to comply with National Electrical Code
(NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian Electrical
Code (CEC) Section 4-010(3). The cord supplied with the switch is in
compliance.
Table 46 on page 86 lists AC power cord specifications provided for each country or
region.
Table 46: AC Power Cord Specifications for an EX4550 Switch
GraphicJuniper Model numberPlug StandardsElectrical SpecificationsCountry/Region
No graphic availableCBL-EX-PWR-C13-ARIRAM 2073 Type RA/3250 VAC, 10 A, 50 HzArgentina
CBL-EX-PWR-C13-AUAS/NZS 3112 Type SAA/3250 VAC, 10 A, 50 HzAustralia
No graphic availableCBL-EX-PWR-C13-BRNBR 14136 Type BR/3250 VAC, 10 A, 50 HzBrazil
Copyright © 2015, Juniper Networks, Inc.86
EX4550 Switch Hardware Guide
To Next Page
Loading...
