9. Place the accessory box vertically by the rear end of the chassis in the shipping carton.
10. Close the top of the cardboard shipping box and seal it with packing tape.
11. Write the RMA number on the exterior of the box to ensure proper tracking.
Packing EX4550 Switch Components for Shipping
To pack the switch components, follow the instructions here.
Ensure that you have the following parts and tools available:
•
Antistatic bag, one for each component
•
ESD grounding strap
CAUTION: Do not stack switch components. Return individual components
in separate boxes if they do not fit together on one level in the shipping box.
To pack the switch components:
•
Place individual components in antistatic bags.
•
Use the original packing materials if they are available. If the original packing materials
are not available, ensure the component is adequately packed to prevent damage
during transit. The packing material you use must be able to support the weight of the
component.
•
Ensure that the components are adequately protected by wrapping them well with
packing materials. Pack the component in an oversized box (if the original box is not
available) with extra packing material around the unit so that the component is
prevented from moving around inside the box.
•
Securely tape the box closed.
•
Write the RMA number on the exterior of the box to ensure proper tracking.
Related
Documentation
• Returning an EX4550 Switch or Component for Repair or Replacement on page 233
• Unpacking an EX4550 Switch
Copyright © 2015, Juniper Networks, Inc.242
EX4550 Switch Hardware Guide
To Next Page
Loading...
