EasyManua.ls Logo

Juniper EX4550 - Connecting and Configuring an EX Series Switch (CLI Procedure)

Juniper EX4550
330 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
family ethernet-switching;
}
}
xe-0/2/7 {
unit 0 {
family ethernet-switching;
}
}
}
protocols {
igmp-snooping {
vlan all;
}
rstp;
lldp {
interface all;
}
lldp-med {
interface all;
}
}
ethernet-switching-options {
storm-control {
interface all;
}
}
Related
Documentation
Reverting to the Default Factory Configuration for the EX Series Switch
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 187
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 190
Understanding Configuration Files for EX Series Switches
EX Series Switches Interfaces Overview
Connecting and Configuring an EX Series Switch (CLI Procedure)
There are two ways to connect and configure an EX Series switch: one method is through
the console by using the CLI and the other is by using the J-Web interface.
NOTE: EX2200-24T-4G-DC switches do not support switch connection and
configuration through the J-Web interface.
This topic describes the CLI procedure.
NOTE: To run the ezsetup script, the switch must have the factory default
configuration as the active configuration. If you have configured anything on
the switch and want to run ezsetup, revert to the factory default configuration.
See Reverting to the Default Factory Configuration for the EX Series Switch.
187Copyright © 2015, Juniper Networks, Inc.
Chapter 15: Performing Initial Configuration

Table of Contents

Other manuals for Juniper EX4550

Related product manuals