Juniper EX4550 - LCD Panel Menus

In an EX4550 switch that is a member of a Virtual Chassis, the first line of the LCD panel
always displays:
•
The slot number (the member ID for the Virtual Chassis member)
•
Role of the switch in the Virtual Chassis (RE for master, BK for backup, and LC for
linecard member)
•
Hostname
The LCD panel operates in boot mode during switchreboot. In the boot mode, the second
line of the LCD panel displays the key milestones in the switch boot process. The boot
mode does not have any menu options. After the boot process is complete, the LCD
panel automatically reverts to the Idle (IDLE) menu.
In idle mode, the second line of text on the LCD panel displays the mode of the network
ports’ Status LED and the number of chassis alarms. The number of alarms is updated
every second.
In status mode, the second line displays:
•
Status of the Virtual Chassis port (VCP)
•
Status of the power supplies
•
Status of the fan modules and the chassis temperature
•
Version of Junos OS for EX Series switches loaded on the switch
In maintenance mode, the second line displays one of the following options, which you
can use to configure and troubleshoot the switch:
•
System halt
•
System reboot
•
Load rescue
•
Request VC port
•
Factory default
•
EZSetup
LCD Panel Menus
The LCD panel has three menus: Idle, Status, and Maintenance. You can toggle between
the LCDpanel menus by pressing the Menu button and navigate through the menu options
by pressing the Enter button.
Table 7 on page 21 describes the LCD panel menu options.
Copyright © 2015, Juniper Networks, Inc.20
EX4550 Switch Hardware Guide