Juniper EX4550 - Monitoring System Log Messages; Table 76: Summary of Key Alarm Output Fields

NOTE: When the switch is reset, the active alarms are displayed.
Meaning Table 76 on page 247 lists the alarm output fields.
Table 76: Summary of Key Alarm Output Fields
ValuesField
Category of the alarm:
• Chassis—Indicates an alarm condition on the chassis (typically an environmental alarm such as
one related to temperature).
• System—Indicates an alarm condition in the system.
Type
Alarm severity—either major (red) or minor (yellow).Severity
Brief synopsis of the alarm.Description
Date and time when the failure was detected.Time
Related
Documentation
Monitoring System Log Messages on page 247•
• Dashboard for EX Series Switches on page 49
• Understanding Alarm Types and Severity Levels on EX Series Switches on page 245
Monitoring System Log Messages
Purpose NOTE: This topic applies only to the J-Web Application package.
Use the monitoring functionality to filter and view system log messages for EX Series
switches.
Action To view events in the J-Web interface, select Monitor > Events and Alarms > View Events.
Apply a filter or a combination of filters to view messages. You can use filters to display
relevant events. Table 77 on page 248 describes the different filters, their functions, and
the associated actions.
To view events in the CLI, enter the following command:
show log
247Copyright © 2015, Juniper Networks, Inc.
Chapter 24: Alarms and Syslog Messages