Juniper EX4550 - Page 178

NOTE: You must remove a fan module only for replacement.
See these topics for instructions for installing and removing components:
•
Installing an AC Power Supply in an EX4550 Switch on page 203
•
Removing an AC Power Supply from an EX4550 Switch on page 204
•
Installing a DC Power Supply in an EX4550 Switch on page 206
•
Removing a DC Power Supply from an EX4550 Switch on page 207
•
Installing a Fan Module in an EX4550 Switch on page 199
•
Removing a Fan Module from an EX4550 Switch on page 200
•
Installing an Expansion Module in an EX4550 Switch on page 209
•
Removing an Expansion Module from an EX4550 Switch on page 211
•
Installing a Virtual Chassis Module in an EX4550 Switch on page 225
•
Removing a Virtual Chassis Module from an EX4550 Switch on page 226
•
Installing a Transceiver in an EX Series Switch on page 215
•
Removing a Transceiver from a Switch on page 217
Related
Documentation
• Cooling System and Airflow in an EX4550 Switch on page 35
• AC Power Supply in EX4550 Switches on page 41
• DC Power Supply in EX4550 Switches on page 44
• Expansion Modules in EX4550 Switches on page 23
• Virtual Chassis Module in EX4550 Switches on page 26
• Pluggable Transceivers Supported on EX4550 Switches on page 93
Copyright © 2015, Juniper Networks, Inc.156
EX4550 Switch Hardware Guide