Juniper EX4550 Hardware Guide

Table 7: LCD Panel Menu Options in EX4550 Switches (continued)
DescriptionMenu Label
The Maintenance menu has the following options to configure and troubleshoot the switch:
•
SYSTEM HALT?—Choose one of the following:
•
Press Enter to halt the switch. Press Enter again to confirm the halt.
•
Press Menu to go to the next option in the Maintenance menu.
•
SYSTEM REBOOT?—Choose one of the following:
•
Press Enter to reboot the switch. Press Enter again to confirm the reboot.
•
Press Menu to go to the next option in the Maintenance menu.
•
LOAD RESCUE?—Choose one of the following:
•
Press Enter to roll back the switch to the previous valid configuration. Press Enter again to confirm the
rollback.
•
Press Menu to go to the next option in the Maintenance menu.
•
REQUEST VC PORT?—Choose one of the following:
•
Press the Enter button to configure an expansion module port or a network port to be a VCP or to
delete a VCP from the switch configuration (when you delete the VCP, the port is reset to an expansion
module port or network port).
•
Press the Menu button to go to the next option in the Maintenance menu.
•
FACTORY DEFAULT?—Choose one of the following:
•
Press Enter to restore the switch to the factory default configuration. Press Enter again to confirm the
restoration. The LCD panel flashes a success or failure message, after which it displays the Idle menu.
•
Press Menu to go to the next option in the Maintenance menu.
•
ENTER EZSETUP?—Choose one of the following:
•
Press Enter to launch EZSetup. Press Enter again to confirm the launch.
EZSetup configures DHCP and enables the J-Web user interface on the switch. The LCD panel flashes
a success or failure message for approximately 10 seconds, after which it displays the Idle menu.
NOTE: You can use EZSetup only on a standalone switch that is in the factory default configuration.
For information about EZSetup, see “Connecting and Configuring an EX Series Switch (J-Web
Procedure)” on page 190.
•
Press Menu to go to the next option in the Maintenance menu.
•
EXIT MAINT MENU?—Choose one of the following:
•
Press Enter to exit the Maintenance menu.
•
Press Menu to return to the SYSTEM HALT? option.
You can disable the Maintenance menu or the options in the Maintenance menu in the LCD panel. See
“Configuring the LCD Panel on EX Series Switches (CLI Procedure)” on page 193.
MAINT
(Maintenance
Menu)
Related
Documentation
EX4550 Switches Hardware Overview on page 3•
• Field-Replaceable Units in EX4550 Switches on page 18
• Connecting and Configuring an EX Series Switch (CLI Procedure) on page 187
• Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 190
• Configuring the LCD Panel on EX Series Switches (CLI Procedure) on page 193
Copyright © 2015, Juniper Networks, Inc.22
EX4550 Switch Hardware Guide

Juniper EX4550 Specifications

Console Connection Settings

baud rate	9600
data bits	8
stop bits	1